Videofied VIA-Pro Instalační manuál stáhnout pdf (Strana 17)

Completing Initial

Configuration/Programming

After the last device is programmed, press ESC/NO.

The display shows END OF CONFIGURATION, then

changes to CLOSE THE PANEL.

STOP!

It is important that you rst mount all devices, then

secure the cover on the control panel. Failure to follow

this order of tasks will cause a tamper condition

from devices.

1. With the display showing CLOSE THE PANEL, do not

press YES.

Mount all system devices at their permanent locations

3. Connect the supplied phone cord into the control panel

phone jack.

Note: The phone line can be run inside the wall

and through the back of the control panel, or it can

be run inside the wire cavity and out the end of the

control panel.

4. With the keypad display showing CLOSE THE PANEL,

secure the cover onto the control panel. The display

shows PANEL TAMPER ON OPEN = ALARM, then

OPERATION COMPLETED?

Press YES. The display shows SYSTEM CHECK

IN PROGRESS.

The system performs a test of all programmed

devices. If all tampers are closed and battery

conditions in all devices are good, the display shows

INSTALLATION SUCCESSFUL, then changes to the

date, time, and current status (DISARMED LVL:3).

If there is no keypad activity for 40 seconds, the

display goes out to conserve battery power.

Initial Configuration/Programming

Installation Sequence

Vid eofied Security System I nstallatio n Manual

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Žádné komentáře

Videofied VIA-Pro Instalační manuál Strana 17